Building a cat shelter: walls

Continuing from building the floor, over the last few days I’ve been building the walls of the cat shelter.

Like the floor, the walls are insulated. Here’s the inside of the center wall, between the shelter and feeder parts, before adding the second plywood layer:

Here I’m laying out the components of the back wall: a couple of vents, and a cat door:

The framing and insulation in place. The horizontal board through the middle will help support the platforms:

Three walls assembled:

A slightly different angle, after adding doorstops for the big maintenance door (pretty much the entire front of the shelter). You can also see supports for the platforms, halfway up the walls:

Laying out the maintenance door:

The inside of the maintenance door, with holes for two windows at the top and a cat door at the bottom, and insulation elsewhere. The door has more substantial framing than the walls, to make sure it’s sturdy, and support the awning:

Here’s the door in place. You may notice that I changed the design a bit from my plans; I decided that vertically-oriented windows would work better:

Finally (for now), I built the awning for the shelter side:

Next up, the walls and door for the feeder side. But the pace will slow down; I took a week off to get this started, but will need to get back to paying work next week.

One thought on “Building a cat shelter: walls

Leave a Reply

Your email address will not be published. Required fields are marked *