Building greenhouse shelving: finished

Yesterday I did the finishing touches on the greenhouse shelving: installing the sink and a second coat of stain.  (See the first, second, and third posts, if you missed them.)

But first, I screwed a couple of small blocks to secure the potting bench to the foundation, both so it can’t tip, and because it’ll eventually have water pipes mounted to it:

Block to secure potting bench

Then I installed the sink:

Sink

It is supported by boards underneath:

Under sink

I also added a hose reel to the side of the potting bench; later I’ll add a tap under the sink for it (and others above). This hose will be for ad-hoc watering of anything in the greenhouse:

Hose reel

The potting bench had hooks on the side, which I removed when mounting the sink, so I put them on the right of the right-hand shelves; perhaps useful for tools:

Hooks

A view of the back of the sink, above the louver vent, from outside:

Outside by sink

Another shot from outside, showing the back of the shelves:

Back

The completed shelves with a second coat of stain:

Shelves with second coat of stain

A wide-angle shot of the shelves:

Shelves

Another view of the shelves and sink:

Shelves and sink

This morning I went out there and put some trays on the shelves, as a demo of usage:

Trays on shelves

Potting bench and sink

Trays on shelves

Right shelves

A wide-angle of the inside of the whole greenhouse:

Whole greenhouse

This concludes this construction project. Hopefully Jenn will get good use out of these shelves, significantly increasing the growing capacity within the greenhouse.

A separate but related project will be to install plumbing: connecting a pipe from the nearby underground pipe, routing it to a tap under the hose reel, another tap for the sink, and a third tap on the back shelves for irrigation. Hooked onto that I’ll have a water timer and splitter, with irrigation tubing going to each shelf, and mister emitters as needed to irrigate the seedling trays. That’ll be a project for another day.

2 thoughts on “Building greenhouse shelving: finished

  1. Pingback: David Sinclair

Leave a Reply

Your email address will not be published. Required fields are marked *