Finishing installing greenhouse irrigation

Yesterday I finished installing the greenhouse irrigation tubing and mister emitters (continuing from the previous post).

I started with the right-hand shelves. Here’s some assembled tubing for the middle one; a tap connector, elbows, and tubing:

Assembled tubing

The four-way splitter (the bottom one is spare) and connected irrigation tubing, enabling the irrigation for each shelf to be controlled separately:

Splitter and tubing

The mister emitters on the lower shelves; the emitters can be positioned as needed, but are just all over the place for now:

Mister emitters

Watering:

Watering

Another shot of the completed irrigation of the right-hand shelves:

Right shelves

On to the shelves at the back. The assembled tubing:

Assembled tubing

Timer, splitter, tubing:

Timer, splitter, tubing

Emitters:

Emitters

We have four soil moisture sensors, that connect to our weather station (which supports up to eight):

Moisture sensor

The completed irrigation, like a bunch of tentacles:

Irrigation done

A wide-angle view of inside the greenhouse:

Wide angle

A view of the outside, showing the shelving:

Outside back view

The front view:

Outside front view

This concludes the greenhouse plumbing and irrigation project! 

3 thoughts on “Finishing installing greenhouse irrigation

  1. Pingback: David Sinclair

Leave a Reply

Your email address will not be published. Required fields are marked *