Some more progress on the duck house project.

I bought a special water dispenser for the ducks (when they’re grown). Ducks have slightly different needs than chickens, in that they need to dip their large bills in water to drink and eat. This waterer has three removable cups for drinking (though one will be unreachable in the corner), a reservoir, and a built-in thermostatically-controlled heater, so the water doesn’t freeze in winter:

Since the waterer was a bit bigger than expected, I also raised the camera up a bit. Here’s the view from the camera:

I tried a bag of feed in the cupboard, to see how well it’d fit. Seems to work laying down or standing up, about as well as I expected. Storing a bag or two of food there will make it easier to refill the food jug:

On to the door trim:

Here’s one of the cupboard doors, with 1×2 trim around the edges. The plywood sticks out a bit on the right edge (in the foreground in this orientation), so it covers the gap between the two doors. Which of course means the other (right-hand) door has to be opened first, which is by some strange coincidence the one I expect to open most:

Both cupboard doors:

I paused for a picnic lunch in the back of the shop (yes, it was still very cold):

Adding trim to the maintenance doors:

I changed my mind about the design of the maintenance doors. Originally I was going to have a single large outer door, with a vertically split inner door. I decided that a single outer door would be too large, so considered doing double doors like the cupboard, but then realized I could combine the inner and outer doors into one set. So I made four-part doors, again with plywood covering the gaps between the doors:

The way it is configured, I can undo one bolt (to be added after painting) to open just the top-left door for a quick peek, or two bolts to open just the top-left and top-right doors to access the ducks without them able to escape (which I expect will be especially useful when they are ducklings), or one bolt to open just the left two doors together (they’ll be connected with a bolt), or the left two and the right two for full access. I think this will be very versatile.

Here’s just the top-left door open:

In addition to the bolts, the doors will be held closed with roller catches. The bottom doors will have theirs mounted under the floor, to be out of the way:

And the top doors will have their roller catches mounted above the doors:

Here’s me using an air finish nailer to attach the board for the top roller catches, captured from the duck camera:

Next up was adding thin strips of wood to make the doors and walls appear like board-&-batten styling, like I did with the cat house. So the first step was to rip (cut lengthwise) some 1×2 boards into 1×0.5 batten strips:

I started adding the battens on the cupboard doors:

Then the maintenance doors:

I also added an extra bit of plywood to the corner that will cover up the two small holes between the four doors:

Finally (for now), battens on the vent cover:

Next up, I will add the batten strips on the walls, do some extra bracing for attaching electrical stuff, and more caulking. Then I’ll be ready to start painting!