It’s been a month since I last did work on the bee shed project, due to a vacation and rainy weather, but yesterday I made more progress.

The project of the day was the door. But first I tweaked the doorframe a little, adjusting the boards on the left side to make the frame more straight, and adding some bracing to help hold the frame to the posts, and provide more support for the corrugated cladding:

Then I built the door itself. I did so on top of three sheets of plywood (that will be used for the shelving), to help make it flat:

I added self-adhesive foam weather stripping around the frame:

The door mounted on hinges:

From further back:

The door (mostly) closed; the two middle cross-pieces are lower than the wall ones, to allow for where the corrugated panels will overlap:

For the door handle, I added a 2×6 block backer and a 2×4 on the left, to protect the hand from the corrugated panel:

Here’s the door handle and latch installed; it’s a bit close to the left, so can only be opened with a right hand, which isn’t ideal; I think I might tweak this to add another board between the left one and the handle, to enable left-handled opening too (nice thing about assembling with screws, easy enough to tweak it):

The latch on the inside; I chose this style latch as it can be opened from inside. I think I’ll add a handle on the inside too, to make it easier to pull the door closed from inside if desired:

The current state of the door; it looks like it sagged a bit while installing the latch (it’ll be braced by the corrugated panels when finished), so I might see if I can fix that too:

We need to do a beehive inspection, and I need to mow the lawns, so it might be a week or so before I can do more work on this. Next up will be the tweaks I mentioned, then I’ll be ready to add the corrugated cladding on that wall and the door.